147
INSTALLER SETTING
146
INSTALLER SETTING
ENGLISH
Installer setting - ventilator
• You can set the product user functions.
• Some functions may not be displayed/operated in some product types.
Menu Applied products Description
Test run setting
DX(Direct
Exchanger) Type
It is the function to set the trial operation at the initial
product installation.
Central control
address Setting
General
It is the function to set the central control address of
the indoor unit during the central controller connection.
Air supply ESP
General/DX Type
It is the function to set the fan speed value
corresponding to the air supply side fan speed.
Air discharge ESP
It is the function to set the fan speed value
corresponding to the air discharge side fan speed.
Temperature sensor
setting
DX Type
It is the function to select the temperature sensor that
will decide the indoor temperature.
Product direction General
It is the function to set the ventilation indoor unit’s
installation direction.
Express ventilation
priority
General/DX Type
It is the function to set the priority of the air supply and
discharge during the express ventilation operation.
RMC master/slave
setting
It is the function to set group control or 2-remote
controller control.
Override master/slave
setting
DX Type
The operation master / slave selection function is to
avoid other mode operations, and it is the function to
prevent the selection of the opposite mode of the
indoor unit set as master by the indoor units set as
slaves.
Dry contact mode
setting
DX Type
Dry contact function is the function that can be used
only when the dry contact devices is separately
purchased and installed.
Fixed fan speed
setting
DX Type
It is the function to set the indoor unit’s fan speed
option to variable or fixed.
Hum. Of Stand-alone
Vent. Mode
General/DX Type
It is the function to set whether to use the
humidification function in the direct cooling type
ventilation’s ventilation single operation.
Hum. Of Vent. With
Heating Oper.
DX Type
It is the function to set the direct cooling type
ventilation’s heating humidification function as auto or
manual.
Menu Applied products Description
Vent. Fan Speed
Alignment
General
It is the function to increase/decrease ventilation’s
standard fan speed from the current status according
to the field environment.
Indoor unit address
verification
DX Type
This function allows you to check the address of the
indoor unit designated by the outdoor unit.
Indoor unit Auto-Start
setting
DX Type
It is a function that sets whether to restore the indoor
unit operation by resuming the previous power-on state
or as power-off state in the power failure
compensation.
CN_EXT setting DX Type
It is the function to set the indoor unit’s Dry Contact
Port to control external input and output according to
DI/DO set by the customer. (It is the function to decide
the usage of the contact point port (CN_EXT) mounted
in the indoor unit PCB.)
ODU function master
setting
DX Type
It is the function to set the outdoor unit’s function
Master / Slave.
Low noise mode
priority setting
DX Type
It is the function to set the main agent of the low noise
mode control. (It is the function to set only one of the
outdoor unit / remote controller can control the low
noise operation.)
Filter check alarm General
This function sets the filter check alarm of the
ventilation product.
UVnano General ventilation
This function sets whether or not UV LEDs are installed
in order to use the Uvnano function.
To Next Page
