GUIDE TO DIFFERENT MODE
OPERATION/OPEN SOURCE SOFTWARE
Different mode operation
Different mode operation is the case when the indoor units’ operation modes are different when
multiple indoor units are installed to one outdoor unit. (Different mode operation doesn’t happen
in the cooling exclusive model.)
• Example of different mode operation
- When one indoor unit is operated in heat while several indoor units one outdoor unit are
operated in cooling, the heating operation is not performed.
- With one outdoor unit, while several indoor units are in heat mode, if one indoor unit requests
in cooling or dehumidification, the operation is not performed.
Open Source Software Notice Information
To obtain the source code that is contained in this product, under GPL, LGPL, MPL, and other
open source licenses that have the obligation to disclose source code, and to access all referred
license terms, copyright notices and other relevant documents, please visit
https://opensource.lge.com.
LG Electronics will also provide open source code to you on CD-ROM for a charge covering the
cost of performing such distribution (such as the cost of media, shipping, and handling) upon
email request to opensource@lge.com.
This offer is valid to anyone in receipt of this information for a period of three years after our last
shipment of this product.
Ventilation Fan Speed Alignment (general ventilator)
It is the function to change the standard fan speed of the ventilation product.
• Select value using [<,>(left/right)] button.
Filter check alarm(general ventilator)
This function sets the filter check alarm of the ventilation product.
• Select value using [<,>(left/right)] button.
Value
Default value 10% increase 10% decrease 20% decrease
Value
Step 0 - 5
197
GUIDE TO DIFFERENT MODE OPERATION/OPEN SOURCE SOFTWARE
196
INSTALLER SETTING
ENGLISH
To Next Page
