151
INSTALLER SETTING
150
INSTALLER SETTING
ENGLISH
ESP setting (air conditioner / general, DX ventilator)
It is the function to set the fan speed value corresponding to each fan speed for easy installation.
• In the installer setting list, select the ESP setting category, and press [OK] button to move to
the detail screen.
OK
NOTE
!
If ESP is incorrectly set, the air conditioner may malfunction.
This function must be set by the installation specialist that holds an installation license.
For ventilation products, separate ESP values are used for the supply and exhaust fans.
NOTE
!
Be especially careful not to switch ESP values corresponding to each fan speed.
Engineering manuals have ESP setting tables that reference air flow and corresponding
value setting to achieve the flow.
The ESP values that can be set may be different for each product and capacity.
Product ESP fan speed value
Air conditioner
Slow
0 ~ 255
Low
Med
High
Power
Ventilation
Low
High
Power
Temperature sensor(2TH) setting (air conditioner / DX ventilator)
It is the function to select the temperature sensor to decide the indoor temperature.
• You can set the following setting values using [<,>(left/right)] button.
• 2TH function’s operation characteristics may be different for each product.
Temperature sensor location Description
Remote controller
Operate the system with wired remote controller’s temperature
sensor
Indoor Unit Operate the system with indoor unit’s temperature sensor
2TH
Cool
Compare the temperatures of the indoor unit and the wired
remote controller and operate with the higher temperature
(There are system operated with lower temperature)
Heat
Compare the temperatures of the indoor unit and the wired
remote controller and operate with the lower temperature
To Next Page
Loading...
