CHAPTER 4: OPERATION 35
MOVE S2
These keys are located right below the display. The functions attributed to them are indicated on the
display by icons.
As the operator advances in the handling, the functions of the keys are automatically reattributed.
The risk of error in handling is therefore virtually reduced given that the proposed functions always
correspond to the circumstance and availability of the bar feeder.
These keys allow to enter values (bar stock diameter, part length, etc.) or parameters.
When an enumeration of parameters or menu sets is proposed, these keys allow the selection.
When a dangerous situation arises, pressing the emergency stop switch interrupts immediately all bar
feeder and lathe functions (if interface is wired accordingly).
To cancel the alarm, release the switch by rotating its red knob counter-clockwise, then press [STOP].
The STOP key allows interrupting the sequence under way.
By pressing the STOP key, allows to exit the setting mode, regardless of the level reached, and to return
to the work screen.
To Next Page
Loading...
