CHAPTER 4: OPERATION 53
MOVE S2
The service parameters allow to configure the bar feeder in its environment and to adapt the interface
connected to the lathe. These parameters are protected with a password, because only LNS (or certified)
technician is authorized to modify them.
Allows to define the bar feeder settings, like:
working speeds;
default torques;
mechanical configuration of the bar feeder.
To configure the interfacing signals between the lathe and the bar feeder, like:
clamping device signal of the lathe;
relays states in the several phases of the production cycle;
configuration of additional inputs.
Access to miscellaneous functions, like:
Working mode (exhibition, simulation, etc.)
Workshop configuration
Allows hiding or showing some menus if they are not useful to the operator.
parameters
application
To Next Page
Loading...
