2 CHAPTER 4: OPERATION
MOVE S2
A regular cleaning of the bar feeder will optimize its quality of working and increase its lifetime.
Wipe down the outside of the bar feeder with a cloth and any regular detergent. For cleaning the inside of
the bar feeder, use a cloth or a smooth brush, however, do not use these on any of the rollers or any
other parts made of synthetic materials. The use of compressed air for cleaning is not advisable, because
chips and other particles can become lodged in sensitive areas and can impede the proper operation of
the bar feeder.
Do not use any corrosive detergent, like acetone. Detergents should never come in
contact to the electrical elements.
Action
Frequency
weekly monthly yearly
Pusher supports I
Pusher belt drive I I
Pusher guides I I
Chain loader I I
Guiding elements I I
Pusher holding rolls I I
Anchoring to ground I
Alignment I
Switches cables I I
Servo amplifier battery I R
PLC battery I R
Safety systems control I I
Hydraulic oil quality R
Hydraulic pump motor function I I
Air valves block control I I
Air conditioning unit purge I I
= Inspect the status, replace if necessary = Replace
To Next Page
Loading...
