LNS QUICK SIX S2 - Set up; Bar Feeder Mechanical Setup; Retraction Device

36 CHAPTER 4: OPERATION
MOVE S2
To facilitate these tasks, the MOVE S2 can be equipped with a retraction system, which allows the
operator to move the bar feeder. The rigidity of the system guarantees a perfect alignment when the bar
feeder is in working position. A safety switch impedes any handling as long as the bar feeder is not in
operational position.
A safety switch impedes any handling as long as the bar feeder is not in operational position.
It is strictly prohibited to use the retraction system before the bar feeder is anchored to the
ground. Please read the safety precautions described at the beginning of this manual
before handling the following devices.
Before handling the retraction mechanism, check to see that the interface cables between
the spindle and the bar feeder are long enough.
- Bar feeder in STOP mode.
- No bar between the bar feeder and the lathe
- Pusher inside the bar feeder
- The area around the bar feeder must be clear
1. Loosen the 8 lock screws (2x4).
2. Pull the bar feeder back.
3. After completing the maintenance operations, bring the bar feeder back in working position,
lock the screws.