Loadrite PRO - Page 10

90 pages

Save Page as PDF

To Next Page

To Previous Page

LOADRITE PRO OPERATING MANUAL

Adds the current load to the total. Also toggles

into Auto Add mode.

Page 13

Clears the short total for the current product. Page 19

Zeroes out the current load. Page 15

Main Page

Default Chapter5
- Table of Contents5
1 Introduction7
- Indicator Lights8
- Keypad8
2 Quick Start Guide11
- Switching on11
- Standby11
- The Warm up Screen11
- The Ready Screen12
- Weighing a Load12
- Static Weigh Function13
- Adding a Load13
- Clearing the Short Total14
- Zeroing14
3 Weighing Overview16
- Weighing Modes16
- Short and Long Totals17
- Accurate Weighing17
- General Method of Weighing18
4 Weighing Procedures19
- Adding a Load19
- Auto Add20
- Subtracting a Load20
- Zeroing21
- Recalling Last Load24
- Viewing Long Total25
- Clearing Totals25
- Tare Function27
5 Product Management29
6 Data31
- Data Edit31
- Automatic Data Prompt36
- Data Suspend36
7 Target Mode38
8 Batch Mode41
- The Batch Screen42
- Viewing the Current Recipe43
- Changing the Recipe44
- Entering the Batch Total45
- Batch Weighing46
- Clearing the Batch Totals47
- Returning to Total Mode47
9 MIX Mode48
- The MIX Screen49
- MIX Weighing49
- Clearing the MIX Totals51
- Returning to Total Mode51
10 Blend Mode52
- The Blend Screen52
- Blend Weighing53
11 Split Mode55
12 Tip off58
13 Menu Options62
- Setup63
- Clock Setting (Clock)63
- Changing Scale Number (Scale#)63
- Clear All Long Totals (Clearall)64
- Auto Add On/Off Setting (Auto Add)64
- Rotary Trigger Position Screen (Trigscrn)64
- LD941 Data Module Properties (Module)65
- Data Edit (Dataedit)65
- Data List (Datalist)66
- Alarm Clock On/Off67
- Alarm Time Set67
- Self Test (Selftest)68
- Uplink (Uplink)68
14 Print Functions69
- Printed Data70
- Print Menu70
15 Obtaining the Best Accuracy76
- Lifting Speed76
- Trigger Point76
- Bounce76
- Centre of Gravity76
16 Error Messages77
- Bouncing Load77
- Check Power77
- Check Transducer77
- Check Trigger77
- Check Zero77
- Lift under Range78
- Module Data Lost78
- Module Error78
- Module Full78
- No Lock78
- Over Target78
- Overload79
- Poor Lift79
- Printer Disabled79
- Printer Error79
- Return under Range79
- Speed Changed80
- Too Heavy, Zero Aborted80
- Warm up Lift80
17 Specifications81
18 Output / Input Connections83
Appendix I Time and Date84
Appendix II Span Calibration Adjustment87

Loadrite PRO - Page 10

Table of Contents

Related product manuals