Loadrite PRO - Print Product Names; Print Product Volume Conversion Factors; Print Stand-by message

LOADRITE PRO OPERATING MANUAL
68
This option only appears if the printout is
not grouped on Totals (e.g. Data1, Data2,
and Data3):
All – All values are used on the printout.
One – Only one of the ‘Grouped’ values is
reported on. For example, if the printout is
grouped on Customer, a report can be
generated on one Customer in the
memory.
Match
All
Once the report is configured, the Loadrite will begin printing (ensure that
the printer is connected BEFORE beginning to configure the report).
The generation and printing of the report may take some minutes,
depending on how much data is stored.
Print Copy
This function sets the number of docket copies to be printed for each
CLEAR event.
Print Data List Names
This function prints out a list of all the Data1 names (normally Customers)
configured in the Loadrite. This function is normally only used to check the
names when the list has been updated.
Print Product Names
This function prints out a list of all the Product names configured in the
Loadrite. This function is normally only used to check the names when the
list has been updated.
Print Product Volume Conversion Factors
This function prints out a list of all the product conversion factors configured
in the Loadrite. This function is normally only used to check the factors
when the list has been updated.
This function is available if volume conversion function is enabled during
installation
Print Stand-by message
The Loadrite normally displayed the service contact details of your local
Loadrite dealer when the stand-by key is pressed. These details can also
be printed if required by using the ‘Print Stand-by’ function.