31
Vista Pro 6 Server: Viewing Mode
Motion Tab
The Motion tab allows you to configure the actions that occur when a motion recording is detected.
For example, after a detection, the system can be set to launch in full screen or begin beeping.
To open the Motion tab:
• Click the Setup ( )button and then click the Motion tab. The Motion tab opens.
CONFIGURING CAMERA NOTIFICATIONS
You can configure the type of action the system produces when motion is detected.
To configure camera notifications:
1. Under Select Camera, select a camera you wish to configure.
2. Under Local Event Notify, check off the events you want to occur when a system detects
motion.
Choices are: Launch Fullscreen, Beep, Red Border and Duration.
Red Border means the screen higlights with a red border when motion is detected.
3. Under Duration, select the check box. In the Duration drop-down menu, select the duration of
how long a notification should last (5~30 seconds).
4. Click OK to save your settings.
Event notifications
Motion Detection Area button
Relay Selection
Camera List
Figure 8.0 Motion tab.
To Next Page
Loading...
Need help?
General