LR Suprasorb CNP P3 - Removing the Suprasorb CNP P3 from the bed mount;universal mount; Connection to wound drainage system and power supply

135
3.7 Removing the Suprasorb
®
CNP P3 from the bed mount/universal mount

1. To remove the Suprasorb
®
CNP P3 from the bed mount/
universal mount, move the green lever to the right and push
the therapy unit gently to the right out of the bed mount.
2. The therapy unit can also be removed from the bed mount/universal mount when the latter
isattached to the sides of the patient’s bed or anchored on arail.
3.8 Connection to wound drainage system and power supply
The connection to the wound drainage system can now be affixed to the exudate pouch tube.
This can be done via either the Suprasorb
®
CNP Drainage Pad or the Suprasorb
®
CNP Deep Drain.
The connection is established via the single-piece connector on their tube ends.
Three steps for connecting the tube using the single-piece connector: See Section 3.3.
PLEASE NOTE
The application of the wound dressing and the connection to
the therapy unit must only be performed by qualified healthcare
professionals. Further information on the Suprasorb
®
CNP Drainage Pad,
Suprasorb
®
CNP Deep Drain and Suprasorb
®
CNP Y Connector can be
foundin the instructions for use for the respective product.