215585 10 Revision A
$
%
Figure 3.3: Top Shield – Left of Center-Link
4. Remove four M10 hex head bolts (A) and flat washers, and
remove top shield (B).
CAUTION
To avoid injury, keep fingers clear of opening at base of anchor.
$
%
&
'
Figure 3.4: Center-Link Anchor – Right of Center-Link
5. Remove cotter pin (B), washer (C), and shipping tag (D).
6. Remove pin (A) from center location and lower forks on
forklift.
NOTE:
Pin should slide out freely. Adjust forklift fork or move
carrier frame until pin is loose. Do NOT use hammer to
remove pin.
$
%
&
Figure 3.5: Center-Link Anchor – Right of Center-Link
7. Move the carrier frame and anchor so pin (A) can be
installed in the working location. Install pin (A) and secure
with washer (B) and cotter pin (C).
ASSEMBLING THE ROTARY DISC PULL-TYPE – WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT
To Next Page
Loading...
