215585 52 Revision A
$
%
Figure 3.106: Header Lighting – Left Side
8. Install light assembly (A) onto the header left end with two
M10 x 20 carriage bolts (B) and lock nuts from the
shipping bag.
NOTE:
Ensure the amber lamp faces the front of header and
reflector faces outboard.
Installing Left Transport Harness
$
%
&
'
(
Figure 3.107: Harness Routing
1. Retrieve transport harness (A) from the shipping bag.
2. Route connectors P201 and P202 on the end of harness (A)
to cover support (D).
3. Using a draw tape or equivalent, route connectors P401
and P404 on the other end of harness (A) through
opening (B) at front of carrier to opening (C) adjacent to
center-link.
4. Route the harness until the plugs reach left light
assembly (E) on the header.
'
(
&
$
%
Figure 3.108: Harness Connection
5. Connect plug P301 (A) from harness (B) to receptacle
P202 (C) on harness (D) (supplied with kit).
NOTE:
Plug P301 (A) was disconnected from the lighting module.
6. Connect plug P201 (E) on harness (D) (supplied with kit)
into the lower output receptacle on the lighting module.
ASSEMBLING THE ROTARY DISC PULL-TYPE – WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT
To Next Page
Loading...
