215585 57 Revision A
Figure 3.118: Control Box Interior
NOTE:
If connections are reversed, the lamp will not illuminate when
the toggle switch is in field mode. Try the following to correct
the issue:
• Check if 10 amp fuse (A) located inside the transport control
box has blown.
• Check for short in wires to solenoid valve on header.
• Check for incorrect wire connections (reversed) at the power
supply or solenoid valve.
6. Place the remote control inside the tractor cab.
Installing Slow Moving Vehicle Sign
The slow moving vehicle (SMV) sign warns road users that your vehicle is moving 40 km/h (25 mph) or less.
Figure 3.119: SMV Sign
1. Retrieve the slow moving vehicle (SMV) sign that was
previously removed.
2. Remove bolts (A), and discard existing bracket (B). Retain
the two bolts, nuts, and washers.
ASSEMBLING THE ROTARY DISC PULL-TYPE – WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT
To Next Page
Loading...
