215585 68 Revision A
$
%
Figure 4.20: Pivot Pin
13. Slowly lower hitch (A) while maintaining pin alignment until
pin (B) is fully inserted. If necessary, use a large soft
hammer to seat pin.
$
%
&
Figure 4.21: Pivot Pin
14. Line up holes in pin (A) with holes in the carrier frame.
Install six M20 x 65 bolts (B) with hardened washers under
the bolt head, and secure with lock nuts (C).
15. Tighten outer bolts (B) first to draw the plate against the
frame, then tighten the inner bolts. Torque bolts to 461 Nm
(340 lbf·ft).
ASSEMBLING THE ROTARY DISC PULL-TYPE – FACTORY-INSTALLED TRANSPORT
To Next Page
Loading...
