Mahr Millimar C 1202 - Page 37

37
Mahr GmbH • Millimar C1202
If a tolerance value is changed but the change has not yet been saved, the "Toler-
ance" text appears in gray.
The changed tolerance values can only be saved when the row with "On" or "Off"
appears in red.
– Use the 4 key to select the Upper
value submenu.
– Use the
▼
key to select the digit and
the ▼ or ▲ key to enter the relevant
value.
– Use the 4 key to conrm the value or
Ó to exit the submenu.
– Use
▼
to select Lower value
or ▲ or Ó to nish editing Tolerance
and to accept changes or Ó to
exit the Tolerance Editor without
applying the changes.
– Use the
key to switch to
measuring mode or Ó to exit the
Feature submenu or 4 to edit the
tolerance or ▼, ▲ to scroll through
the submenu.