Maintenance work on the carrier
7.15 Hydraulic system
25.11.2016
Maintenance manual 3 302 364 en 7 - 113
GMK 4100L-1
Changing filters 3
and 4
• Remove the receptacle (1).
• Place the filter in a receptacle.
• Change the filter (2).
• Replace any defective parts, where
necessary.
• Fill the receptacle with clean oil.
• Put the receptacle on and tighten it.
• Change the filter on the opposite side in the
same way.
O
Risk of damage to the environment from filter residues
Store used hydraulic oil filter inserts in suitable receptacles and have them
disposed of properly by qualified personnel.
To Next Page
Loading...
