Maintenance work on the carrier
7.14 Hydraulic system
13.02.2018
Maintenance manual 3 302 719 en 7 - 97
GMK6300L-1
Changing filters 3
and 4
Filter 3 is installed on the left side and filter 4 is on the right side.
• Remove the receptacle (1).
• Place the filter in a receptacle.
• Change the filter (2).
• If necessary, replace any defective
parts (repair set).
• Fill the receptacle with clean oil.
• Put the receptacle on and tighten it.
• Change the filter on the opposite side in
the same way.
O
Risk of damage to the environment from filter residues
Store used hydraulic oil filter inserts in suitable receptacles and have
them disposed of properly by qualified personnel.
To Next Page
Loading...
Need help?
General
