Maintenance work on the carrier
7.3 Engine
13.02.2018
Maintenance manual 3 302 719 en 7 - 21
GMK6300L-1
7.3.7 Changing the oil and oil filter
Oil, spare parts,
tools
– Receptacle, approx. 50 ltr (14 gal);
à p. 2 - 4.
– Torque wrench for a torque of 55 Nm (40.5 lbf ft).
– Connecting piece and hose (tool box);
à p. 7 - 92.
Prerequisites
• Find out the prescribed oil specification and about the need to shorten
the maintenance interval under special operating conditions;
à Engine
manufacturer’s documentation
.
• Find out about the safety instructions and the sequence of steps to change
the oil and the oil filter;
à Engine manufacturer’s documentation.
– The truck crane must be level.
– The engine must be switched off and secured against unauthorised use;
à p. 2 - 3.
Changing
If a valve is already mounted on the oil pan:
s
Engine oil in
litres (gal)
Designation
according to
DIN 51502
Specification
Classification
GROVE part no.
42 (11.1) HD - CD MIL-L 2104 C
DB 228.31/.51
SAE 5 W-30
03329588
Designation Quantity GROVE part no.
Oil filter with gasket 1 04161614
O
Risk of environmental damage due to leaking consumables.
Always let consumables drain into suitab
le receptacles. Wipe up
any consumables that escape.
Store/dispose of consumables and any soaked equipment properly.
Ask about the applicable regulations.
O
Risk of environmental damage due to leaking consumables.
If a valve is mounted on the oil pan, use the delivered connecting piece
with hose and a receptacle with adequate capacity to drain the oil.
To Next Page
Loading...
