2-73
TMS800E SERVICE MANUAL HYDRAULIC SYSTEM
Published 01-29-2014, Control # 496-00
1. Install the wiper ring, seal and wear rings on the inside of
the head. Make sure the seals are assembled properly
and in the correct direction.
2. Install the O-ring and backup ring on the outside of the
head.
3. Install the hydrolock seals and seal on the outside of the
piston.
4. Install the spacer onto the rod.
5. Install the head onto the rod.
6. Lubricate the rod with clean hydraulic oil.
7. Lubricate the piston seals and head O-ring with clean
hydraulic oil.
8. Remove the cover from the barrel. Insert the rod and
attached part into the barrel with a slight twisting motion.
9. Using a chain wrench or spanner wrench, screw the
head into the cylinder barrel.
10. Pressurize and cycle the cylinder with hydraulic oil
pressure. Test the cylinder at 207 bar (3000 psi). Check
for proper operation and any leakage. Make repairs as
needed.
CAUTION
Do not use air pressure to cycle or pressurize the cylinder.
Reference Only
To Next Page
Loading...
Need help?
General
