Manitowoc Grove TMS800E User Manual

7-37
TMS800E SERVICE MANUAL POWER TRAIN
7
GROVE
Published 01-29-2014, Control # 496-00
Maintenance
Troubleshooting
SYMPTON PROBABLE CAUSE SOLUTION
Chatter.
Loose, broken, or worn engine
mounts.
Tighten or replace mounts.
Loose or cracked clutch
housing.
Tighten or replace.
Rear axle attach bushings
worn.
Replace bushings.
Misalignment. Align.
Oil or grease on facings.
Install new facings or disc
assembly.
Warped or bent driven disc
assembly.
Replace,
Improper disc facing
thickness.
Install proper disc assembly.
Worn pilot bearing. Replace.
Wrong spring pressure in the
cover assembly.
Use correct cover assembly.
Cross shaft bushings worn. Replace the bushings.
Release levers not parallel. Recheck installation.
Aggressive (grabby).
Excessive backlash in the
power train.
Worn parts.
Warped driven disc. Install a new disc assembly.
Worn hub splines. Install a new disc assembly.
Worn splines on splined shaft. Replace shaft.
Improper facing material.
Install proper driven disc
assembly.
Insufficient release.
Broken or loose engine
mounts.
Tighten or replace.
Excessive idling speed. Adjust to factory specifications.
Loose or worn facings. Replace.
Improper facing thickness.
Install the proper driven disc
assembly.
Insufficient release
(continued).
Drive lugs binding.
Check pressure plate drive lugs
for proper clearance 0.152 mm
(0.006 in).
Reference Only

Manitowoc Grove TMS800E Specifications

General

Brand	Manitowoc
Model	Grove TMS800E
Category	Construction Equipment
Language	English