marposs TESTAR E4N - Page 86

84
10
ERR 37
ERR 38
ERR 39
ERR 40

ERR 60
ERR 42
ERR 70

ERR 72
ERR 80
ALPHANUMERIC
DISPLAY
7-SEGMENT DI-
SPLAY
ERROR TYPE DESCRIPTION MENU ACTION
Programming
THRESH.= error
Program THRESH= to a

programmed)
Programming
The measurement re-
solution is incompatible
with the operating range

Modify RESOLUT=
or
W.R.X=
(X = channel)
Programming
TOLER+= or TOLER-=
are not programmed
TOLER-= is set higher
than TOLER+= or the
tolerance is outside the
programmed range.
Program
Correct values for TO-
LER+= or
TOLER-=
Programming
The tolerance pre-limit is
incorrectly programmed.
APPRCH+= is higher
than TOLER+= or
APPRCH-= is lower than
TOLER-= or APPRCH-=
is higher than AP-
PRCH+=
Program APPRCH+=
or APPRCH-= correctly
-
grammed)
Programming
Programming
SCALE= incompa-
tiblle with M.UNIT=
and M.SYST= already
programmed
DELTA and TIME values
are not programmed
Program SCALE= to a
correct value
Program DELTA and
TIME
Programming
ABSOLUT.= not pro-
grammed
Program ABSOLUT.= to

Programming
DISPLAY= not program-
med
Program DISPLAY=
CENTRAL or BOTTOM
Programming
LUMIN= not program-
med
Program LUMIN= NOR-
MAL, HIGH or LOW
Programming

programmed or master

MASTER2) is missing or
incorrect
Program

MASTER 2= correctly.
Check that the correct
master is being used.
ADVANC.:
ADVANC.:
/
TR.ADJ.:
(ADVANC.:)
MEASURE:
MEASURE:
MEASURE:
MEASURE:
MEASURE:
ADVANC.:
ADVANC.:
MEASURE:
PROGRAMMING ERROR MESSAGES AND SOLUTIONS