Mash Seventy - Page 45

Chapter 3 Engine Section 2 Engine Disassemble and Re-assemble
3—7
Tighten the bolts of the lower connecting plate of the
engine according to the specified torque.
As in Fig. 3.2.22.
Engine front bracket bolt: 23N.m (2.3Kg.m)
Note：
Apply a small amount of sealant to the bolt.
Tighten the engine ground wire.
As in Fig. 3.2.23
Position Throttle body as shown in Fig.3.2.24
Install the clutch release lever as shown in Fig. 3.2.25.
Note：
Align the surface A of the separation lever groove
with the notch mark B on the separation camshaft.
Loosen the rear axle nut and drive chain regulator nut.
Install the engine sprocket as shown. As in Figure 3.2.26.
Fig.3.2.22
Fig.3.2.23
Fig.3.2.24
Fig.3.2.25
A
B
Fig.3.2.26