Wintest - Issue 5.a
GUF511.8
AUTOTRONIC 5 - PowerShuttle - Programming and setting
parameters
B . Setting parameters
Switch on the ignition key to carry out this operation.
The engine must be stopped.
Parameter setting is necessary:
- if the former Autotronic 5 has been replaced by a
new one,
- when improvements to one or more functions have
been made through parameter setting,
- if a programming has been carried out.
Click on the “Tools” icon and then on “AUTO5 label -
PowerShuttle”.
Wintest
MA-11-01281A
AUTO5 label - PowerShuttle
Table of AUTO5 constants
Programming AUTO5
List of AUTO5 error codes
To Next Page
Loading...
