MASSEY FERGUSON 5400 - Page 763

Wintest - Issue 5.a
GUF511.7
AUTOTRONIC 5 - PowerShuttle - Programming and setting
parameters
During programming, several error messages may be
displayed.
Message:
- File cannot be opened
- Select a soft
- Select a calculator
- Calculator cannot be unlocked
- Bank 1 cannot be erased
- Bank 2 cannot be erased
- Bank 3 cannot be erased
- Bank 4 cannot be erased (Boot)
- Programming error
- End-of-programming error
- Reboot error
- Table change reset error
- File name length error
- File run error
Correction method:
- Depending on the type of message, try to follow the
requested indications.
- Cut the ignition and turn it back on.
- Check the CAN BOX interface connections with the
16-pin diagnostics connector.
- The AUTOTRONIC 5 unit is defective.
- If necessary, reinstall the Wintest software on your
PC.
I
MPORTANT: When programming with a Boot update,
unexpected interruption of programming can be fatal
for Autotronic 5.
To avoid Autotronic 5 breakdown:
Do not disconnect the calculator.
Restart programming (Wintest will offer to reprogram
only the faulty calculator to make it operational).
N
OTE:If the l’Autotronic 5 programming is interrupted
unexpectedly, switch off the ignition key and then
switch it on again. This enables you to resume
programming.
Error
File cannot be opened