WINTEST - Issue 5.a
GUF513.17
AUTOTRONIC 5 - PowerShuttle - Error codes
TR25: Intermediate speed sensor
Description
Location: close to the gearbox cover (Fig. 16)
Induction sensor.
- Connectors 1: Signal
- Connectors 2: Ground
Signals:
Resistance when stopped: 450 Ohm +/- 20
Alternating voltage when pinion is rotating
To adjust the air-gap:
- Apply a small amount of Loctite 5922 to the thread
- Screw the sensor home in abutment on the pinion
- Unscrew the sensor by 3/4 turn
- Tighten the locknut to approximately 6 Nm
Possible error codes
TR16TR24
TR25
MA-11-01264A
Fig. 16
MA-11-01265A
1
2
1
2
Fig. 17
Errors Description Solutions
Resetting the system
after clearing error
221 Intermediate speed sensor
error
Check:
- Sensor status
- Sensor resistance of 450 Ohm, as well as
alternating voltage when pinion is rotating
- Contacts
- Harness connections
- Wiring
Press the clutch pedal to
contact the BOC
To Next Page
Loading...
