EasyManua.ls Logo

Mazda CX-9 2007 - Pcm; Pcm Function [Mzi-3.5]; Function List; Structure

Mazda CX-9 2007
614 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CONTROL SYSTEM [MZI-3.5]
01-40–6
PCM FUNCTION [MZI-3.5]
id0140c1105300
Function List
The control descriptions are as shown below.
End Of Sie
PCM CONSTRUCTION/OPERATION [MZI-3.5]
id0140c1105400
Structure
A 140-pin (two-block) PCM connector has been adopted.
Function Description
Drive-by wire control
The drive-by-wire control calculates the optimum target throttle valve opening angle at all
ranges of engine speeds and controls the throttle valve actuator.
Variable valve timing control Changes the intake valve timing according to engine operation conditions.
Fuel injection control Performs optimum fuel injection according to engine operation conditions.
Fuel pump control
Performs energization of the fuel pump relay only when the engine is running (operates fuel
pump).
ESA control Controls ignition to optimum timing according to engine operation conditions.
Evaporative purge control
An appropriate amount of evaporative gas is fed into the dynamic chamber by the driving of
the purge solenoid valve according to the engine operation conditions.
HO2S heater control
Based on the control of the front and rear HO2S heater, a stabilized oxygen concentration is
detected even at low exhaust gas temperature and feedback control of fuel injection even
during cold engine start is made possible for improved cold temperature emission
performance.
A/C cut-off control
The current application (energize/non-energize) to the A/C relay (magnetic clutch) is
controlled according to the engine operation conditions.
Electrical fan control
Through cooling of the radiator and condenser by operation of the cooling fan according to
vehicle conditions, engine reliability and cooling performance have been improved.
PCV valve heater control
Operates the PCV valve heater and PCV valve heater fitting when the intake air temperature
is low.
CAN Used for communication with CAN related module and DLC-2.
1BQ 1BL
1BI
1BG
1BE
1AI
1AG1AK
1AM
1AC
1AQ
1AO
1BC 1AE
1BP 1BK
1AY
1AW 1AS 1H1M 1C1Q1Y 1U
1AU
1BA1BN
1F1K1O1AA 1A1W 1S
1BJ 1BF 1AH1AL 1AD1AP1AX 1AT 1I1N 1D1R1Z 1V1BB1BO
1J 1E
1BR 1BM 1BH 1AJ1AN1AR1BD 1AF1AZ 1AV 1G1L1P1AB 1B1X 1T
2BQ 2BL
2BI
2BG
2BE
2AI
2AG2AK
2AM
2AC
2AQ
2AO
2BC 2AE
2BP
2AY
2AW 2AS 2H2M 2C2Q2Y 2U
2AU
2BA2BN
2F2K2O2AA 2A2W 2S
2BR 2BM
2BJ
2BH
2BF
2AJ
2AH2AL
2AN
2AD
2AR
2AP
2BD 2AF2AZ
2AX 2AT 2I2N 2D2R2Z 2V
2AV
2BB2BO
2G2L2P2AB 2B2X 2T
2BK 2J 2E
PCM
WIRING HARNESS-SIDE CONNECTOR
ac9uuw00002429
3423-1U-06H(01-40).fm 6 ペー   

Table of Contents

Other manuals for Mazda CX-9 2007

Related product manuals