EMISSION SYSTEM [MZI-3.5]
01-16–11
01-16
Type B Construction
• An SST is not used with this type.
• The connector can be disconnected by pinching
the retainer tab pulling the connector.
• To connect the quick release connector properly,
push it into the fuel pipe until a locking click sound
is heard.
• New quick release connectors are fitted with a
checker tab that prevents improper fit. This
checker tab cannot normally be removed. When
the quick release connector is properly connected
to the fuel pipe, the lock is released and the
checker tab comes off. Due to this, it can be
verified that the quick release connector is
completely connected.
Type C Construction
• An SST is not used with this type.
• Mainly consists of a retainer and O-ring. The quick release connector is integrated with the joint port and
therefore cannot be disassembled.
• When the quick release connector is connected,
the fuel pipe projection is locked at the clamp lock
point. To release the quick connector lock for each
type, follow the procedure in the order shown in
each figure.
RETAINER
ac9uun00000440
CHECKER TAB
FUEL PIPE
ac9uun00000030
FLATHEAD SCREWDRIVER
QUICK RELEASE CONNECTOR
RETAINER
acxuun00000028
3423-1U-06H(01-16).fm 11 ページ ２００６年１１月２２日 水曜日 午後２時４分
To Next Page
Loading...
