EasyManua.ls Logo

Mazda CX-9 2007 - Dsc;Rsc Construction

Mazda CX-9 2007
614 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DYNAMIC STABILITY CONTROL/ROLL STABILITY CONTROL
04-18–4
DSC/RSC CONSTRUCTION
id041800817800
The dynamic stability control (DSC)/roll stability control (RSC) system consists of the following parts. While
each part has a regular function in other systems, only the function during DSC/RSC control is listed.
End Of Sie
Part name Function
DSC/RSC HU/CM
Makes calculations using input signals from each sensor, controls brake fluid pressure
to each wheel, and actuates each function (ABS, EBD, TCS, DSC and RSC) of the
DSC/RSC system.
Outputs the torque reduction request signal, vehicle speed signal and DSC/RSC
system warning control data via CAN lines.
Controls the on-board diagnostic system and fail-safe function when there is a
malfunction in the DSC/RSC system.
PCM
Controls engine output based on signals from the DSC/RSC HU/CM.
Transmits engine speed, tire and shift position data via CAN communication to the
DSC/RSC HU/CM.
TCM
Transmits gear/selector lever target position data via CAN communication to the DSC/
RSC HU/CM.
DSC indicator light
Informs the driver that the RSC is operating.
Informs the driver that the DSC is operating (vehicle sideslip occurring).
Informs the driver that the TCS is operating (drive wheel is spinning).
TCS OFF switch Transmits driver intention to release engine TCS control to the DSC/RSC HU/CM.
TCS OFF light
Informs driver that engine TCS control has been released due to TCS OFF switch
operation.
ABS wheel-speed sensor Detects the rotation condition of each wheel and transmits it to the DSC/RSC HU/CM.
Combined sensor
Detects the lateral-G (vehicle speed increase), forward-G (vehicle speed increase),
yaw rate (vehicle turning angle) and roll rate (vehicle rolling angle) of the vehicle and
transmits them to the DSC/RSC HU/CM.
Brake fluid pressure sensor
(Builtinto DSC/RSC HU/CM)
Detects the fluid pressure from the master cylinder and transmits it to the DSC/RSC
HU/CM.
BCM
Transmits the steering angle and steering angle sensor condition via CAN lines to the
DSC/RSC HU/CM.
3423-1U-06H(04-18).fm 4 ペー   

Table of Contents

Other manuals for Mazda CX-9 2007

Related product manuals