ON-BOARD DIAGNOSTIC
04-02–9
04-02
ON-BOARD DIAGNOSTIC SYSTEM ACTIVE COMMAND MODES FUNCTION
id040200110700
• The active command modes function is used for optionally selecting active command modes items of input/
output parts preset in the dynamic stability control (DSC)/roll stability control (RSC) hydraulic unit (HU)/control
module (CM), and to operate them regardless of CM control.
• To protect the hydraulic unit interior, operate output related parts for only 10 s or less when using the active
command modes function.
Active Command Modes Table
End Of Sie
Command name Output part name Operation
Operation
condition
PMP_MOTOR Pump motor
Off/On
Ignition switch at
ON
P_SIGNAL TCM
PWR_RLY Valve relay
SSR_INTL
DSC/RSC sensor (combined sensor, steering angle
sensor)
V_LF_INL LF inlet solenoid valve
V_LF_OTL LF outlet solenoid valve
V_LR_INL LR inlet solenoid valve
V_LR_OTL LR outlet solenoid valve
V_RF_INL RF inlet solenoid valve
V_RF_OTL RF outlet solenoid valve
V_RR_INL RR inlet solenoid valve
V_RR_OTL RR outlet solenoid valve
V_STB_L LH stability control solenoid valve
V_STB_R RH stability control solenoid valve
V_TRC_L LH traction control solenoid valve
V_TRC_R RH traction control solenoid valve
3423-1U-06H(04-02).fm 9 ページ ２００６年１１月２１日 火曜日 午後５時１２分
To Next Page
