AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
05-17–39
05-17
SELECTOR INDICATOR LIGHT CONSTRUCTION/OPERATION [AW6A-EL, AW6AX-EL]
id051723103200
Construction
• The selector indicator light is built into the instrument cluster.
• When in the P, R, N or D range, the TCM detects the selector lever position based on an analog signal from the
TR switch. When in the M range, the TCM detects the selector lever position based on a signal from the M
range switch inside the selector lever component.
• When the instrument cluster receives a range signal or a gear position signal from the TCM via CAN
communication, the selector lever position and the gear position indicator lights illuminate or flash accordingly.
Operation
Gear position indicator light flash
• When the driver’s down-shift operation is cancelled, the gear position indicator light flash twice.
— When the TCM cancels a shift operation, all of the signals are pulsed ON/OFF and when finally input to the
instrument cluster, the on signal (ex. M1 signal when in 1GR) and the remaining three off signals (M2, M3,
M4, M5, M6) are reversed to off and on signals respectively.
• Based on a combination of input signals from the TCM, the instrument cluster determines the gear number
(1GR displayed as “1”), and flashes the gear position number in the gear position indicator light and the
selector indicator “M” light.
End Of Sie
M
*:
P
R
N
D
1
TCM
INSTRUMENT CLUSTER
SELECTOR
INDICATOR LIGHT
GEAR POSITION INDICATOR LIGHT
ABOVE DIAGRAM SHOWS FLASHING WHEN IN 1GR
CAN
1W
1X
2GR
3GR
4GR
5GR
2GR
3GR
4GR
5GR
1GR
1GR
6GR
6GR
A14
A6
ac9uun00000442
3423-1U-06H(05-17).fm 39 ページ ２００６年１１月２１日 火曜日 午後５時１７分
To Next Page
Loading...
