ON-BOARD DIAGNOSTIC
04-02–8
ON-BOARD DIAGNOSTIC SYSTEM PID/DATA MONITOR FUNCTION
id040200110500
• The parameter identification (PID)/data monitor function is used for optionally selecting input/output signal
monitor items preset in the dynamic stability control (DSC)/roll stability control (RSC) hydraulic unit (HU)/control
module (CM) and reading them out in real-time.
PID/DATA Monitor Table
End Of Sie
PID/data monitor item Input/output part
Unit/Condition
(Tester display)
ACCLMTR Combined sensor G
BOO_ABS Brake switch Off/On
CCNTABS Number of continuous DTCs —
LAT_ACCL Combined sensor (lateral-G value) G
MCYLI P Brake fluid pressure sensor MPa
PMP_MOTOR Pump motor Off/On
SHIFT_P TCM Off/On
PWR_RLY Valve relay Off/On
ROLL_RATE Combined sensor °/s
SWA_POS Steering angle sensor °
TCS_OFF_SW TCS OFF switch Off/On
V_LF_INL LF inlet solenoid valve Off/On
V_LF_OTL LF outlet solenoid valve Off/On
V_LR_INL LR inlet solenoid valve Off/On
V_LR_OTL LR outlet solenoid valve Off/On
V_RF_INL RF inlet solenoid valve Off/On
V_RF_OTL RF outlet solenoid valve Off/On
V_RR_INL RR inlet solenoid valve Off/On
V_RR_OTL RR outlet solenoid valve Off/On
V_STB_L LH stability control solenoid valve Off/On
V_STB_R RH stability control solenoid valve Off/On
V_TRC_L LH traction control solenoid valve Off/On
V_TRC_R RH traction control solenoid valve Off/On
WSPD_LF ABS wheel-speed sensor (LF) KPH, MPH
WSPD_LR ABS wheel-speed sensor (LR) KPH, MPH
WSPD_RF ABS wheel-speed sensor (RF) KPH, MPH
WSPD_RR ABS wheel-speed sensor (RR) KPH, MPH
YAW_RATE Combined sensor (yaw rate value) °/s
3423-1U-06H(04-02).fm 8 ページ ２００６年１１月２１日 火曜日 午後５時１２分
To Next Page
Loading...
