EasyManua.ls Logo

Mazda CX-9 2007 - Page 204

Mazda CX-9 2007
614 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DYNAMIC STABILITY CONTROL/ROLL STABILITY CONTROL
04-18–16
DSC/RSC CM PART FUNCTION
id041800818300
• The dynamic stability control (DSC)/roll stability control (RSC) control module (CM) makes calculations using
signals input from each sensor, outputs a brake fluid pressure control signal to the DSC/RSC hydraulic unit
(HU) to actuate DSC/RSC system functions and outputs an engine output control signal to the PCM.
• The DSC/RSC HU/CM controls the following functions:
Function Table
Function name Contents
Antilock Brake System (ABS) control function • Controls brake fluid pressure when braking to maintain directional
stability, ensure steerability and reduce stopping distance.
Electronic Brakeforce Distribution (EBD) control
function
• Constantly controls proper distribution of brake fluid pressure to the front
and rear wheels according to vehicle load, road surface and vehicle
speed conditions to prevent early lock-up of the rear wheels.
Traction Control System (TCS) control function • Controls traction to within the road surface friction limit and according to
road and driving conditions to improve starting and acceleration
performance, and safety.
DSC control function • Suppresses strong over-steer and under-steer tendencies when turning
by controlling engine output and braking of each wheel to assure driving
safety.
RSC control function • Suppresses vehicle attitude due to overspeed during evasive steering or
cornering by controlling engine speed and wheel braking to improve
vehicle stability during cornering.
Brake assist function • Controls the fluid of the wheel cylinder during emergency braking,
provides increased fluid pressure to each wheels.
CAN signal function • Transmits the wheel speed signal to the PCM using CAN
communication.
On-board diagnostic system • A function that allows important parts of the DSC/RSC control system to
perform self-diagnosis. In case a malfunction occurs, the warning lights
illuminate to alert the driver, and at the same time a DTC is stored in the
DSC/RSC HU/CM.
• When a malfunction is determined as a result of the on-board diagnosis
test, system control is suspended or limited to prevent any dangerous
situation while driving.
3423-1U-06H(04-18).fm 16 ページ 2006年11月22日 水曜日 午後2時38分

Table of Contents