Megmeet M5-N Series User Manual

170 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

1

M5-N Series Servo System

User Manual

Document Version: V1.0

Archive Date: 2023/12/14

BOM Code:

Shenzhen Megmeet Electric Co., Ltd. provides full technical support for our

customers,customers can contact local Megmeet offices or customer service centers, or

directly contact Megmeet headquarters.

Shenzhen Megmeet Electric Co., Ltd.

All rights reserved. The contents in this document are subject to change without notice.

Shenzhen Megmeet Electric Co., Ltd.

Address: 5th Floor, Block B, Unisplendor Information Harbor, Langshan Rd., Science &

Technology Park, Nanshan District, Shenzhen, 518057, China

Website: www.megmeet.com

Tel: +86-755-86600500

Fax: +86-755-86600562

Service Email: driveservice@megmeet.com

Customer Service Tel: +86-400-666-2163

Table of Contents

Questions and Answers:

M
Melissa MartinezAug 19, 2025
What to do if Megmeet M5-N show drive overcurrent?
- J
  Julie MartinAug 19, 2025
  If your Megmeet Servo Drives indicate a drive overcurrent, it could be due to several reasons. The motor cables might have poor contact, requiring you to fasten any loose connectors. Alternatively, the motor cables could be grounded, in which case you should replace the motor if the insulation is poor. Another possibility is a short circuit in the motor UVW cables, which can be resolved by correctly connecting the motor cables. If the motor itself is damaged, replacing it is necessary if the resistance is unbalanced. An improper gain setting causing motor oscillations can be fixed by re-adjusting the gain. Lastly, check the encoder cable for incorrect wiring, corrosion, or looseness; re-welding or fastening the encoder cable may resolve the issue.
J
Jennifer Young MDAug 21, 2025
Why Megmeet M5-N Servo Drives show drive overheat?
- M
  Michelle ChenAug 21, 2025
  If your Megmeet Servo Drives are overheating, it could be due to a high ambient temperature. To resolve this, improve the cooling conditions and reduce the ambient temperature. Alternatively, the servo drive might be experiencing multiple overload operations. In this case, wait for 60 seconds to reset after overload, consider increasing the drive and motor capacity, increase the acceleration and deceleration time, and reduce the load.

Megmeet M5-N Series Specifications

General

Brand	Megmeet
Model	M5-N Series
Category	Servo Drives
Language	English

Related product manuals

Megmeet SPS-NE Series