Megmeet M5-N Series User Manual

3
Safety Precautions
Operation without following instructions can cause death or severe personal injury.
Operation without following instructions can cause medium or slight personal injury or
damage to the product and other equipment.
◆
Please install the product on the incombustible materials (e.g., metal), otherwise, fire may be caused.
◆
Do not place any combustible material near the product, otherwise, fire may be caused.
◆
Do not install the product in the environment with explosive gas, otherwise, explosion may be caused.
◆
Only qualified personnel can wire the drive, otherwise, electric shock may be caused.
◆
Never wire the drive unless the input AC supply is completely disconnected, otherwise, electric shock
may be caused.
◆
The grounding terminal of the drive must be reliably grounded, otherwise, electric shock may be caused.
◆
The cover must be properly closed before power up, otherwise, electric shock and explosion may be
caused.
◆
When powering up the drive that has been stored for over 2 years, the input voltage must be gradually
increased with the voltage regulator, otherwise, electric shock and explosion may be caused.
◆
Do not touch the terminals when the product is powered up, otherwise, electric shock may be caused.
◆
Do not operate the drive with wet hands, otherwise, electric shock may be caused.
◆
Maintenance operation can not be conducted until 10 minutes has passed after disconnecting the power
supply. Meanwhile, be sure to confirm that the charge LED is completely off and the DC bus voltage is
below 36V, otherwise, electric shock may be caused.
◆
Only qualified personnel can replace the components. Do not leave any wire or metal parts inside the
drive, otherwise, fire may be caused.
◆
The bare parts of the terminal lugs in the main circuit must be wrapped with insulation tape, otherwise,
electric shock may be caused.
◆
Please install the drive on the place that can withstand the weight of the drive, otherwise, the drive may
drop and cause human injury or property damage.
◆
Do not install the drive in the environment with water splash (e.g., near the water pipe), otherwise, you
may suffer the property loss.
◆
Take care not to drop any foreign objects, such as the screws, gaskets and metal bars, into the drive,
otherwise, fire and property damage may be caused.
◆
Do not install and operate the drive if it is damaged or its components are not complete, otherwise, fire
and human injury may be caused.

Megmeet M5-N Series Specifications

General

Brand	Megmeet
Model	M5-N Series
Category	Servo Drives
Language	English