Chapter 1 M5-N Servo System Selection
Brake resistor
wiring terminal
U, V, W
Servo motor
power
terminals
Servo motor UVW power terminal
Fig.1-6 Schematic diagram of each part of M5-N servo drive (SIZEB)
Table 1-2 Description of each part of M5-N servo drive (SIZEB)
CN3, CN4
Communication interface
Two RJ45 ports for EtherCAT communication
CN5
Type-C USB
communication port
Connect the USB of the computer through this port, you can adjust the
parameters of the drive and debug the performance.
5-digit 8-segment digital tube for status monitoring, parameter display and
setting.
5 keys for parameter adjustment and display status switching, etc.
DB15 female connector, control IO interface, used to connect with external IO
and host controller.
1394 female connector for connecting motor encoder
It is used to indicate the state of the bus power. The indicator light indicates
To Next Page
Loading...
Need help?
General
