TURBOCHARGER
SERVICE MANUAL NUMBER 22
90-860074--1 FEBRUARY 2002 Page 7C-23
6. Using new sealing washers on hollow bolt, install coolant vent line to turbocharger
exhaust housing as shown. Tighten hollow bolt securely.
7. Clean sealing surfaces and using a new gasket, install oil feed pipe as shown. Tighten
screws securely.
8. Install turbocharger-to-intake duct hose as shown. Tighten hose clamp at turbocharger
securely.
9. Fit air filter to turbocharger and tighten clamp securely.
70989
a
b
c
d
f
g
e
h
i
Typical (All Similar)
a-Sealing Washers
b-Hollow Bolt
c-Coolant Vent Line
d-Turbocharger Exhaust Housing
e-Gasket
f-Oil Feed Pipe
g-Screw (2)
h-Air Filter
i-Hose Clamp