Page 82
Set Sensor Parameter
optoNCDT 1420
7.6.6 Access Authorization
The assignment of a password prevents unauthorized changing of settings on the sensor. When delivered,
the password protection is not enabled. The sensor operates in the user level Professional. The password
protection should be enabled after configuration of the sensor. The default password for the expert level is
000.
i
The default password or a user-defined password is not changed by a software update. The profession-
al password is independent of the setup and is therefore not together loaded or saved with the setup.
The following functions are available for the user:
User Professional
Password required no yes
Viewing settings, signal processing, outputs, system settings yes yes
Changing settings, signal processing, outputs, system settings no yes
Changing password no yes
Changing between the measurement and video signal chart types no yes
Scaling diagrams yes yes
Setting factory setting no yes
Fig. 48 Rights in the user hierarchy
Type in the default password 000 or a user-defined password in the
Password field and confirm with Login.
Change with a click on the Logout button in the mode user.
Fig. 49 Change in the professional user level
To Next Page
Loading...
Need help?
General