Version 1.10 Pag. 188 di 203
Even though this is a single test, it must be carried out as PROTOCOL, because this allows to have a
particular print report showing the 'level' based on the following table:
The test ends when you stay outside the test area for more than 3 seconds.
To display the test results go to Results, select the option 'Protocols' from
Display>Data and choose the protocol with the symbol and double-click
or use <Display> from the Test Analysis list.
Figure 126 - Selecting a protocol to be printed
The printed report includes total time and result, as well as average flight and contact times of all 5
tests, total time deviation as percentage and fatigability index.
To Next Page
Loading...
