Chapter 5 Troubleshooting
146
Error
numbe
r
Message Cause Corrective action
073F HD HEATER CTRL
ERR
• A problem was detected
with the head heater
control.
0740 HD HEATER TEMP
HIGH
• A high head heater
temperature was
detected.
0801 (C) OPCODE • A problem was detected
with the control PCB.
• Turn off the control PC, then turn off
the main power. Wait briefly before
turning the control PC and the main
power back on.
0802 (C) SWI
0803 (C) PFTCH ABRT
0804 (C) DATA ABRT
0806 FW/SIO bit
0807 FW/SIO wbsy
080E FW/FROM prm
080F FW/SIO vch
0811 FW/SIO read
0815 FW/SIO rsrc
0816 FW/FROM WRC
0817 FW/SaveArea
081B FW/STACK OV
0826 FW/PrmSaveBuf
0828 PRG ERR L*****
0829 FW/ERASE TIMEOV
083A PARAMETER ERROR • A parameter error was
detected.
083B MESSAGE ERROR • A message between tasks
contained an invalid value.
0916 ROM MISMATCH • The wrong firmware may
have been updated.
• Check to determine if the firmware is
for the machine. If the firmware is for
the machine, contact your local
dealer or our service office.
091D COVER OPEN • The maintenance cover is
open.
1. Close the maintenance cover.
2. Clear the alarm on the touch panel.
"Clearing Alarms"(P. 99)
0B0F DIO PCB Uvpow • There is a problem with
the UV drive 32B PCB
LED POW (+36V)
• Turn off the control PC, then turn off
the main power. Wait briefly before
turning the control PC and the main
power back on.
0B25 HDC DIRECTION • A problem was detected
with the scan control.
0B27 HD LOGIC FUSE • Problem detected with
print head control PCB
0B28 HD DRIVER FUSE
0B29 HD VLT ERR
To Next Page
Loading...
