Connecting the Power
22
• The JFX550-2513 power cable is connected to SW1 and SW2. It must not be connected
to SW3.
3
Secure the live and neutral wires of each cable to the terminal block, and then attach the
ground wire to the protective ground screw hole indicated by the ground symbol.
• The terminal block screws should be tightened to a torque of 1.8 Nm.
Switchboard
SW1
SW2
SW3
INLET1
INLET2
INLET3
Arrow A
View from
arrow A
Cable strap ×6
Stainless steel saddle ×3
4
After laying cables, use the included stainless steel saddle and cable straps to neatly organize
the cables.
• Insert the cable straps (TM-193-3 x 6) to the six locations indicated in the figure in Step 3, and
tighten the band to bundle the cables together.
• Three sizes of the stainless steel saddle are included. Please select the appropriate saddle size
according to the cable outer diameter.
Saddle model number Compatible cable outer diameters Quantity
LS3AV16JB Ø16.0 to 16.3 mm 3
LS3AV18JB Ø16.4 to 18.3 mm 3
LS3AV20JB Ø18.4 to 20 mm 3
To Next Page
Loading...
