MIMAKI JFX550-2513 - Page 78

Chapter 2 Printing
78
4
Select the image data imported.
• The image is displayed in the tab for JFX550-2513, JFX600-2513 selected in "Printer name".
5
Check the settings and alter as necessary.
• Specify the following settings by clicking the function icons shown on the right-hand side of the
screen:
(General Print): Specifies settings like enlargement/reduction and number of copies.
(Print Condition): Selects a color profile for the media and ink set loaded in the machine.
• For more information, refer to the RasterLink reference guide. https://mimaki.com/
download/software.html
6
Prepare a job (RIP data) from image data.
• Click (Execute) from the function icons on the right-hand side of the screen. Select "RIP and
Print", then click [Start].
• When the output destination folder is [SharedJob]: The RIP job is added to the MPC job list.
"When saved to [SharedJob]"(P. 78)
• When the output destination folder is [HotFolder]: "Job receiving" is displayed in the lower-left
corner of the MPC screen, and printing starts. "When saved to [HotFolder]"(P. 79)
• When the output port is set to [Ethernet], the job is saved in the specified shared folder
with the job name determined automatically by RasterLink.
When saved to [SharedJob]
Saving data in [SharedJob] adds the jobs to the MPC job list.
l
Job checking procedure
Jobs that have been successfully loaded are saved in [SharedJob].