New Device
Confirm
Cancel
Confirm Device SN
SN: GT6004343M
If the connection is successful, your pump displays a success message. If the
Sensor feature is turned on, the Connection icon
appears on the status
bar.
If your pump does not find your transmitter, see the following procedure, If
your pump does not find your transmitter. If your pump finds multiple devices,
skip to the steps on page 178.
If your pump does not find your transmitter:
1. Place the transmitter back on the charger and make sure your transmitter is
fully charged before continuing.
2. Place your pump and transmitter within an arm's length of each other.
3. Select Retry on your pump and immediately remove the transmitter from the
charger to start the search process.
4. If the search is unsuccessful the second time, select Cancel when the No
Devices Found message appears and then follow the instructions in Wirelessly
connecting your pump and transmitter using Manual Connect, on page 179.
If your pump found multiple devices:
1. Write down the serial number for your transmitter. The serial number can be
found on the back of your transmitter.
2. Place the transmitter back on the charger and make sure your transmitter is
fully charged before continuing.
3. Select Next from the Multiple Devices Found message to display the Enter
Device SN screen.
4. Manually enter your device serial number by following the instructions,
starting with step 4 in Wirelessly connecting your pump and transmitter using
Manual Connect, on page 179.
178 Chapter 10
MP6025957-024 / A
RELEASED
To Next Page
Loading...
