Mitsubishi Electric MELFA FR CR700 Series User Manual

13-260 13-260
13.7.7. EtherNet/IP parameters
This sets the EtherNet/IP information in the robot controller.
Set parameters while connected to the robot controller.
Double-click [Field network parameter] -> [EtherNet/IP] under the [Parameter] item to be edited from the project
tree.
After you change a parameter value, you can rewrite the parameters in the robot controller by clicking the [Write]
button.
Figure 13-75 EtherNet/IP parameters
You can copy network settings of the computer to the screen by clicking the [Copy PC network settings] button.
You can reference explanation of the displayed parameters by pressing the [Explain] button.
This function can only be used with CR800-D/CR750-D/CRnD-700/CRn-500 series robot controllers.
Caution

Mitsubishi Electric MELFA FR CR700 Series Specifications

General

Manufacturer	Mitsubishi Electric
Category	Robotics
Payload Capacity	7 kg
Reach	908 mm
Degrees of Freedom	6
Repeatability	±0.02 mm
Weight	27 kg
Series	MELFA FR CR700
Robot Type	Collaborative
Installation	Floor, Wall, Ceiling