506
12 DATA USED FOR POSITIONING CONTROL
12.8 Control Data
[Cd.42] Stop command processing for deceleration stop selection
• Sets the stop command processing for deceleration stop function (deceleration curve re-processing/deceleration curve
continuation).
Fetch cycle: At deceleration stop causes occurrence
■Setting value
• Set with a decimal.
• Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 392 Control data
0: Deceleration curve re-processing
1: Deceleration curve continuation
K
Stop command processing for
deceleration stop selection
Setting
value
To Next Page
Loading...
