Mitsubishi Q Series - Page 163

6 - 6 6 - 6
MELSEC-Q
6 PROGRAMMING
[Cascade control setting]
Cascade Bias ............................................................."-500"
Cascade Gain............................................................."2000"
(b) Automatic refresh setting (Refer to Section 5.5)
Error code ..................................................................."D50"
CH1 Measured Value (PV) setting ............................"D51"
(c) Intelligent function module parameter write (Refer to Section 5.3.3)
Write the parameter values of the intelligent function module to the PLC
CPU.
Perform this operation on the intelligent function module parameter setting
module selection screen.