Mitsubishi Q Series - Page 237

Index - 1 Index - 1
INDEX
[A]
Advancing completion flag ............................ 3-86
Alert 1 to 4 mode setting ............................... 3-82
Alert setting value.......................................... 3-68
Alert function.................................................. 3-18
Alert dead band setting ................................. 3-79
Alert definition................................................ 3-61
Alert delay count............................................ 3-79
Alert occurrence flag (XnC to XnD) .............. 3-45
Alert setting value 1 to 4................................ 3-68
Applicable Systems......................................... 2-1
Approach flag ................................................ 3-62
Approach range setting................................. 3-80
AT additional lag............................................ 3-70
AT bias........................................................... 3-75
AT differential gap ........................................ 3-70
Auto tuning command (Yn4 to Yn5) ............. 3-46
Auto tuning function ........................................ 3-7
Auto tuning status flag (Xn4 to Xn5)............. 3-43
Automatic backup setting after auto tuning
of PID constants ............................................ 3-79
Auto tuning setting function........................... 3-12
Fast response mode.................................. 3-12
Standard mode .......................................... 3-12
[B]
Buffer memory list ......................................... 3-49
[C]
Cascade bias................................................. 3-81
Cascade control function .............................. 3-32
Cascade gain ................................................ 3-81
Cascade monitor ........................................... 3-81
Cascade ON/OFF ......................................... 3-80
Cold junction temperature measured value . 3-62
Command advancing .................................... 3-85
Control mode ................................................. 3-73
Control mode monitor ................................... 3-62
Control output setting at CPU stop error
occurrence..................................................... 3-23
Control response parameter ......................... 3-72
[D]
Data resolution .................................................3-3
Data storage on FeRAM................................3-16
Default setting registration command (Yn9) .3-47
Default value write completion flag (Xn9) .....3-44
Derivative action (D-action) ...........................1-10
[E]
Error code ......................................................3-60
Error Code List.................................................8-1
End status flag ...............................................3-86
Error flag (Xn2)...............................................3-42
Error reset command (Yn2)...........................3-46
Execution pattern ..........................................3-87
Execution pattern monitor..............................3-87
Execution times monitor ................................3-86
External dimension diagram....................... App-1
External wiring..................................................4-6
[F]
FeRAM backup command (Yn8)...................3-47
FeRAM write completion flag (Xn8) .............3-43
FeRAM write failure flag (XnA)......................3-44
FeRAMs PID constant read command .........3-78
FeRAMs PID constant completion
read/write flag.................................................3-63
Forced PID control stop.................................3-14
Forced PID control stop command
(YnC to YnD)..................................................3-48
Forward/reverse action select function .........3-13
Forward/reverse action setting .....................3-75
Function summary ...........................................3-6
Function version...............................................2-5
[G]
GX Configurator-TC.........................................2-3
GX Developer ..................................................2-3
Ind