Mitsubishi Q Series - Page 238

Index - 2 Index - 2
[H]
Handling precautions ...................................... 4-1
Hold command .............................................. 3-84
Hold status flag.............................................. 3-86
[I]
I/O signal list .................................................. 3-41
Indication accuracy.......................................... 3-4
Input range ................................................... 3-65
Input sensor .................................................... 3-3
Integral action (I-action) .................................. 1-9
Internal current consumption .......................... 3-2
[L]
Loop disconnection detection function ......... 3-15
Loop disconnection detection dead band..... 3-77
Loop disconnection detection judgment time
....................................................................... 3-77
[M]
MAN output setting........................................ 3-74
Manipulated value (MV value) ...................... 3-61
Measured Value (PV value).......................... 3-61
Module ready flag (Xn3)................................ 3-43
[O]
Online module change .................................... 7-1
Operation at input disconnection .................... 3-5
Output variation limiter .................................. 3-69
[P]
Performance specifications............................. 3-1
Parts identification ........................................... 4-3
Pattern end output flag.................................. 3-86
PID action ...................................................... 1-11
PID constant setting ...................................... 3-68
PID control system .......................................... 1-5
PID continuation flag .................................... 3-80
PID operation................................................... 1-6
Primary delay digital filter setting .................. 3-71
Procedure before starting the operation......... 4-2
Program control function............................... 3-24
Program control RUN/RESET ..................... 3-76
Program pattern .............................................3-91
Pattern end output time of program
pattern ........................................................3-93
Program pattern final segment ..................3-91
Program pattern iteration ...........................3-92
Program pattern link setting.......................3-91
Segment set value (SV) setting .................3-94
Segment time scale ...................................3-94
Segment Zone PID data No ......................3-94
Wait zone of program pattern ....................3-93
Programming ...................................................6-1
Proportional action (P-action)..........................1-8
[Q]
Q62HLC control status controlling output
signal and buffer memory settings and
control status..................................................3-36
[R]
RFB limiter function........................................3-13
[S]
Sampling period .............................................3-40
Scaling function..............................................3-34
Scaling range upper limit • lower limit ...........3-83
Scaling value .................................................3-81
Scaling width upper limit • lower limit ............3-82
Segment monitor............................................3-84
Segment remaining time................................3-84
Sensor compensation value setting ..............3-68
Set value (SV) setting ....................................3-66
Set value monitor ...........................................3-62
Setting change command (YnB) ...................3-48
Setting change completion flag (XnB) ..........3-45
Setting change rate limiter ............................3-74
Setting mode/operation mode command
(Yn1)...............................................................3-46
Setting/operation mode status (Xn1) ............3-42
Simplified analog I/O function........................3-35
Soak time criteria ...........................................3-80
Start mode......................................................3-88
Ind