10
2 Basic Operations
No. 99MAM029A
Tips
Only our specied paper (Parts No. 09EAA082, 10 rolls/pack) shall be used. The printer paper for
the product is a paper with excellent durability. Nevertheless, the print becomes faint over time due
to the characteristics of thermal paper. In the case of extended storage (5 years or longer) or use for
ofcial documents, the use of photocopies is recommended. As the print disappears, discoloring or
paper deterioration may occur if cutting uid or other substances get on the printer paper, storing of
the copies is recommended.
5
Close the printer paper cover pressing both ends of the cover top surface with the printer
paper edge protruding a little from the paper cutter.
Tips
Close the cover paying attention so the printer paper does not hang over the right and left side
edges of the cover.
6
Switch on the power and feed the printer paper forward.
1
Press
POWER
, and then release a nger
from the key.
» The power LED is lit, the printer paper
is fed, and then "Mitutoyo", "DP-1VA
LOGGER", the mode number, time/date,
number of log data and log condition are
printed.
2
Hold down
FEED
to feed the printer pa-
per forward by approximately 100 mm.
1
2
Power LED
Tips
• After the printer paper is set, it is necessary to feed it by pressing
FEED
without fail. Self-align-
ment function for the paper position to reduce the possibility of a paper jam is activated by
pressing this button.
• When the power LED is not lit, check whether the batteries with sufcient charge remaining are
rmly set or whether the AC adapter is connected properly.
• If the power LED blinks, change the batteries as promptly as possible. If continuing to use with-
out changing, the malfunction where the power off switch does not work may occur.
• When holding down
POWER
again, the power turns off. On/Off operation of the power shall be
performed at an interval of 5 seconds or more. On/Off operation of the power within a shorter
time than the above may cause a malfunction. If it happens, load the batteries or AC adapter
again and restart.