68
6 Maintenance and Troubleshooting
No. 99MAM029A
6.2.2 Other Error Displays
There are other error displays (symptoms) below than the power LED blinking. Address
them according to the error contents.
Error display
(symptom)
Types of er-
rors
Causes Handling method
Immediately after
the power on, all the
LEDs start blinking.
System error
y A fatal error is
occurring with
the product
y The service
temperature is
either too high or
too low.
Turn off the power and turn it
on again.
"Û OVER FLOW Û"
is printed out.
Overow
The calculable
range is exceeded.
Delete the data by pressing
CLEAR
.
y The [-NG] and
[+NG] LEDs are
blinking.
y A red line appears
on the printer
paper.
Out of printer
paper.
No printer paper.
Replace the printer paper.
"2.1.2 Setting the Printer Pa-
per and Power-on" on page 9
The [-NG] and [+NG]
LEDs are blinking.
Cover open
(head up).
The printer paper
cover is opened.
Close the printer paper cover.
"Û NO GAGE Û" is
printed out, and the
[-NG] and [+NG]
LEDs are blinking.
No connect-
ed measuring
instrument.
y No measuring
instrument is
connected.
y The connection
cable is broken.
y The connection
cable has a con-
tact failure.
y Connect a measuring in-
strument.
y Replace the connection
cables.
y Check the connector por-
tion of the connection cable.
"Û FORMAT ER-
ROR Û" is printed
out, and the [-NG]
and [+NG]
LEDs are blinking.
Data format
difference
The format of the
input data is differ-
ent.
y Delete all the data pressing
CLEAR
. There may be the
possibility whereas the
measurement data with
digimatic specications 1
and 2 are mixed in input.
"5.1.1 SYSTEM/WORK
MODE Selection and Print
Contents" on page 61
y Replace the connection
cables.
y Check the connector por-
tion of the connection cable.
To Next Page
Loading...
General